ACDC Garage Door Remote Green Button _XI-TRANSM

Free Standard Delivery Australia-wide only 


  • Brand New Remote
  • Key Ring Attachment
  • Battery
  • Coding Instructions

Warranty -  01 year manufacturer's warranty (This warranty covers failure due to manufacturer's fault)

Compatibility List:

This remote is compatible only with the below ACDC motors:

  • RollerGlide
  • PowerGlide

Featuring 4 buttons in an unique design with a half round GREEN button & three black buttons in a white case. A wide key-ring connection makes attachment easy and the rounded edges makes the remote feel good in the hand. Working on 433.92MHz with ACDC's own rolling code algorithm, this remote has a great feel & looks good.

Weight .029 kg



Does Not Apply


Does not apply


Number of Buttons

Remote Colour


Colour of Buttons

Black, Green

AS62368.1 Battery Compliant

Not Applicable

Battery Technology



Genuine, Keyring, Wireless


433.92 MHz

Power Source

Battery Powered


1 Years*

Items Included

Battery, Installation Instructions, Keyring Attachment, Remote


Frequency 433.92MHz
Code Type Rolling Code
Body Type Key Ring
Number of Buttons 4
Button Colour Green/ Black
Case Colour White
Remote Size 52 x 32 x 11mm
Range < 40 meters
Item Contains Lithium Coin/Button Battery No
Battery Type 27A
Access Type Tool Required
AS62368.1 Compliant N/A

Programming Instructions

ACDC Roller-Glide

  • Remove the white plastic light cover (take care as the push button is attached.
  • Press and Release LEARN button
  • Press the button on the NEW remote for 2 seconds.
  • Pause for 2 seconds
  • Press the same button again for 2 seconds

Deleting memory

Press and hold the LEARN button for 15 seconds.

ACDC Power-Glide and Euro-Glide

  • Press and release LEARN button A dot will illuminate in the corner of the LED display
  • Press the button on the NEW remote for 2 seconds.
  • Pause for 2 seconds
  • Press the same button again for 2 seconds The dot in the corner of the display will flash to confirm the code has been accepted
  • Turn off Motor.

ACDC Slim-Glide

  • Remove the light cover.
  • Press K1 button on the control board, the coding light will come on.
  • Press the button on the NEW remote for 2 seconds. Coding light will turn off
  • Pause for 2 seconds
  • Press the same button again for 2 seconds The coding light will flash 8 times then turn off indicating the coding has been coded successfully.

Deleting Memory

-Press and hold button K1 down for approximately 8-10 seconds – code light will come on and then go off indicating a successful delete.


  • Press and hold down button “P2” MEMO: The LED “L4” will flash slowly – at the same time press the remote button you want to open / close the device
  • Hold down button “P2” MEMO until LED “L4” starts to flash again
  • Release the button “P2” MEMO – The LED will continue to flash.
  • Within 15 seconds activate the remote button again – at the end of coding: the LED “L4” will remain lit for 2 seconds

Deleting Memory

Keep both buttons “P2 & P3” pressed down for more than four seconds.- LED “L4” will remain lit during the entire delete time (about 8 seconds) – LED “L4” switches off when the



Brand ACDC
Shipping Weight 0.0250kg
Shipping Width 0.030m
Shipping Height 0.010m
Shipping Length 0.060m
Shipping Cubic 0.000018000m3

Be The First To Review This Product!

Help other Automatic Doors Australia users shop smarter by writing reviews for products you have purchased.

Write a product review

More From This Category